Plumbing Repair Service In Hillsboro Beach FL

Installed 2 50 gal water heaters with recirculating pump in closet down stairs in garage . Also installed 2 55 gal water heaters with recirculating pump on top floor in utility closet . Customer is responsible for running the electrical to the second water also added 2 ball valves to heater down stairs to isolate on tank so electrician can hook electrical to second heater.

We did not do the work as the way the ac unit was situated if we touched or moved it in any way it could have caused a major leak

Upon today’s visit customer wanted garbage disposal installed, an estimate for installing a toilet, as well as a titan tankless heater swap out. We provided estimates, customer declined at this time. When customer is ready she would like a bundle deal, I mentioned we could possibly do garbage disposal for free if she supplies unit. Thank you for calling John The Plumber. -Shane

Upon arrival customer needed two dual emergency valves changed. Due to the high volume of water, we had to charge an additional $267.30. After emergency stops were installed they were tested for proper functionality. They were operational as they should be. Thank you for calling John The Plumber -Shane This is an estimate to add to dual emergency stop replacement due to high amounts of residual waiting in main and exceeding time to preform work.

Came to provide customer estimate on water heaters for upstairs and downstairs units. Provided estimate to customer and customer will get in contact with us go perform work.

This is an estimate to replace a 40 gal low 3500w water heater and bringing it up to code compliant connections for customers safety and inspection. Customer called to inquire an estimate to replace their water heater. Upon arrival after evaluation of the unit in question we also brought to customers attention that the main water shut off valve was a gate valve and needed replacement to a saftey mechanism ball valve. After conversing with customer over other estimates he had in place we finalized with an approval on the 25th of this month to begin and finalize install. Building shut down will be placed by then as management had been contacted.

...

The toilets in the master bath and both guest house baths were removed and disposed of. New Kohler Santa Rosa one-piece elongated white toilets with seats were installed. The stop valve in the right guest house bath toilet was not functioning, so it was replaced with a 1/4-turn stop valve. All work was tested and is functioning properly. The stop valve will be replaced with a 1/4-turn valve.

John, the plumber was called out today to the customers apartment due to an issue with his kitchen faucet continuously dripping. After doing a brief inspection, technician saw that the leak was coming from the head of the kitchen faucet not being tightened. Once technician tightened the sprayer the leak stop. Technician does recommend customer get his faucet replaced due to the wear and tear on the sprayer hose on the kitchen faucet. Technician also noticed that the valve underneath the kitchen sink that supplies the cold water should be replaced. In order to replace that valve customer will also have to run a new icemaker line to the refrigerator. Technician will also give customer an estimate on replacing his 10 year old water heater with new valves for the apartment, and the water heater included. Water heater estimate will also include a disconnect for the electrical and permits.

Couldn’t make shower head and handheld work with trim hitting the shower valve

Today, we met with the property manager, who informed us that the entire house was experiencing drain backups. Additionally, he requested a toilet replacement. Scope of Work & Findings: • Drain Backup Issue: We provided a quote for snaking the entire home’s drainage system and conducting a camera inspection after clearing the clog. • Toilet Replacement: We also quoted the installation of the new toilet, which the property manager approved. Work Performed: • After pulling the existing toilet, we discovered that the current valve had a 3/8” outside diameter (OD) instead of the standard 3/8” inside diameter (ID). This prevented us from connecting a new supply line. • Upon further inspection, we determined that the valve was a German-style connector, likely imported during the original toilet installation. We explained the situation to the property manager, who approved replacing the valve. • After installing the new valve and toilet, we thoroughly tested for leaks—none were observ

The toilet in the left-side guest house bathroom was backed up. I used a stool auger through the toilet to clear the stoppage, then flushed and tested to ensure proper function. The customer requested the replacement of this toilet, along with the right-side guest house bathroom toilet and the junior bathroom toilet in the main house. A deposit was taken for the installation of Kohler Santa Rosa one-piece ADA-height elongated toilets (1.6 GPF) in biscuit.

Upon arrival customer showed me water heater space that they would like water filtration customer wants water softener for her hair also would need to replace water heater upon installation At this time customer only wanted estimates will call for install

Arrived to customer, found that whole home water filtration system next to tanked heater has shark bite Push to connect fittings on it as well as filtration system in condo being plastic housing. At this time, we estimates to customer for fixing properly, customer declined at the moment. We flushed out heater, and you are good to go!

Price is to replace two cooling tower valves. Valves are coroded and contractor wants the, replaced. Doesn’t include hook up to unit and doesn’t include supply line. Tested our work and no leaks were observed. Lines were left off and contractor will call an AC company to replace the supply lines. Also recommend that the building replaces the shark bites on the cooling tower to avoid a flood. Also recommend replacing titan tankless unit since it has been opened and altered.

The customer has a 40-gallon Rheem water heater from 2006 in the hall closet. I provided an estimate to replace it with a new 40-gallon Rheem unit, including a 1/2" T&P valve, pan, and a wired switch, with a permit required. The customer plans to call back when ready to proceed.

On arrival, customer has single bowl kitchen sink draining slow. Gave estimate to run K 50 through drain of kitchen sink. Customer does not want to proceed forward at this time..

Upon arrival, customer advised me that her son told her that she had a leak in the kitchen. Customer is not physically down here in the unit. Her son comes down to stay in it periodically. She wanted a diagnostic of the kitchen to make sure there are no leaks. I ran a diagnostic on her ice line for the freezer. Determined there was no leak. I also ran a diagnostic on the hot and cold angle stops under the sink. I determined that there was a compression tee as the cause of the leak. I recommended that we change both angle stops and compression tees on both the hot and cold line to dual stops. She agreed. After checking for any other issues while I was here, I advised customer that her toilet fill valve was compromised and kept running without stop continuously into the overflow. I facetime customer so she was able to see all of these issues. She agreed to replace the fill valve in the toilet. Perform extensive Leak detection in kitchen. Check 1/4” ice line behind fridge. Check dishwas

Upon todays visit, we descaled 2 tankless water heater with the haymaker process. After descaling unit, we flushed out systems and ran hot water to continue to flush out unit. Tested water temps and units are operating as they should. Due to whole home filtration system both tankless water heaters were in very healthy condition. We recommend doing this tankless descaling process every 2 years. When we arrived tankless heater had no error code, when we left and after testing there were also no error codes. Customer says a few days ago they had intermittent hot water. Thank you for calling John The Plumber!

Upon arrival the customer explained to me that there was no cold water in the lavatory faucet, I checked the faucet and realized it was simply the set screw that was loose. I used an Allen key to tighten the set screw which probably took about 10 seconds. The water returned and the customer was happy. I never seen the home owner on this visit, there was I would assume a handy man that showed me around and also signed in the customer place.

Performed home inspection see estimate for recommendations for repairs and installs . Checked all plumbing in hose for leaks and function.

Run snake through floor drain 45 feet to clear stoppage . Ran toilet several times to ensure stoppage was clear no warranty on stoppages. Had the chief sign off on the work and he said to email invoice for payment.

Upon arrival we were shown to a leak from the upstairs shower. Maintenance already cut the hole so we were able to see that the shower drain is causing the leak. The drain is a special order part so the work couldn’t be done today and the customer has to speak with her son to make a final decision so the estimate has been sent to them with the scope of the work

removed existing steamer and installed customer provided unit connected all plumbing and drainage ports to existing connections in home,specifications of customer supplied new unit are significantly different than previous unit removed on electrical connection,in which it has altered the connection to wiring ports for proper power distribution since existing wire does not reach to connect to new unit,configuration needed will need to be done by licensed electrician for full function of the steamer unit.

Upon arrival customer has to have water heater, kitchen faucet, garbage disposal, 2 bathroom faucets, tubular drains underneath bathrooms, tub spout, dishwasher line, main water shut off, and all stops underneath sinks replaced. Customer will be supplying kitchen faucet, garbage disposal, and 2 bathroom faucets. We will supply main water shut off, water heater, dishwasher supply line, tub spout, tubular drain piping, and emergency stops underneath sinks.