Plumbing Repair Service In North Lauderdale FL

This job is for Renee in the office we provided and installed two wolverine brass Quarter turn hose bibs.

Renee had issues with her sewer system. Jason and I accessed roof and made our way to the back bathroom vent. We ran 65 ft of camera. Drain had no obstructions. There was only one belly of water about 2 feet long where the clean out is. We ran multiple flush test from both fixtures and water was flowing efficiently. There was no need for snaking the line. Drain flowing efficiently

Unspecified ...

Upon arrival, customer showed us where the heater was in her storage closet outside we ran test on elements and thermostats top upper element and upper thermostat are shot. Will you reset it thermostat then it re-chirped so customer is aware that we will need to reschedule and come back out with the right material to restore her with hot water. Customer is aware.

Upon arrival to the location, I met with Ana, Carlando was not present at the moment. She explained she had some work done recently in the home, and they had to shut down the main valve and after they turned the main back on, they just haven’t been getting any hot water. She also stated she flipped the breaker in and off a few times but nothing changed. I told her I’ll check to see if you’re getting any power to the unit. It turns out she’s not getting power to the water heater, nor to the wall connection. When I looked at the breaker, I noticed it was a 20 double pole amp, which should be a 25 amp for a 4500 watt unit. I explained to Ana the situation, and she said it made sense because from the beginning they would run out of hot water, and it would never stay hot enough, just warm. I advised her she would need to get an electrician to change out the circuit breaker.

During diagnostics test, it was determined that the handle in the valve is seized inside of shower diverter manifold customer is requesting an estimate to change out manifold to a conversion kit. All parts and labor comes with one year, no hassle warranty. JTP is not responsible for any damage to tile due to converting shower valve.

Mitigate and diagnose, shower handle and valve issues in master shower. If customer agrees to do the repair 50% of this estimate will be credited towards the repair. Sold mowen conversion customer requested 8am start Monday morning

Upon arrival customer needs a dishwasher, kitchen faucet, tubular drain, garbage disposal, emergency stops, and an AAV installed. Estimate provided customer needs to have kitchen finished in order for installation of materials. Thank you for calling John The Plumber

Upon arrival customer had a leak under kitchen sink. Further inspection, waste arm is higher thank garbage disposal drain so it is fighting itself to drain. We did replace 90 on garbage disposal and installed p trap. Tested for proper functionality, operating as it should. Thank you for calling John The Plumber -Shane

Upon arrival tankless water heater Eemax, was not getting power. Further diagnosis we called manufacturer and spoke with technical support. They had us send a picture of installation. We then removed faceplate to show wiring to unit and the electrical as well as installation was correct. Unfortunately at this time the technical support representative advised us that an electrical will have to diagnose power issue to unit. Thank you for calling John The Plumber. -Shane

Upon arrival I spoke with the maintenance person who wanted me to run the camera in unit 1F from the toilet that he would pull and reset. The reason for this is there are roots growing from around the flange and getting into the sewer line causing stoppages. I provided and estimate for the camera inspection and they declined it at this time.

Customer has high water bill. install ball valve for main shut off on right side of home. perform pressure test. pressure did not drop in home. Pressure held in home but dropped in water service going to home. Leak is in water service. Dug down where water service comes out of ground going into home and in front of meter found no leaks. Water service needs to be replaced.

Upon arrival customer had a toilet backed up due to possible toy in toilet. We advised customer to camera sewer after auger and estimate was signed. While we were moving boxes to access water heater a glass filled box fell and broke. We gave customer $100.00 credit towards broken box. After auger customer declined sewer main evaluation. Toilet will also need to be reset due to sewer smell in bathroom. After auger of toilet, customer no longer wanted camera evaluation. Estimates proved customer declined Thank you for calling John The Plumber.

Upon arrival I found the problem as soon as I turned on the dishwasher, Josh did not reattach the dishwasher hose. I ran the dishwasher on the drain cycle and water poured underneath the kitchen sink. Reattached hose and no more leak. Everything now worked as it should.

Upon arrival, the customer required multiple items to be replaced and installed. We began by removing the old, rusted, and corroded laundry bibs and replaced them with new, secure bibs to ensure leak-free connections. Next, we replaced the existing angle stops under the kitchen sink with two new dual stops, which were needed to accommodate the water supply for both the dishwasher and ice maker. The customer-supplied dishwasher was then installed, with all water, drainage, and electrical connections properly secured and tested for functionality. Additionally, we installed a new water line for the refrigerator’s ice maker, ensuring a secure, leak-free connection to the newly installed dual angle stops. All appliances were tested to ensure proper operation, and plumbing connections were thoroughly inspected for leaks. The work area was cleaned, and all systems were left fully operational.

On arrival,Customer has jackhammered floor exposing 2 inch cast-iron drain that has crack. would need to replace approximately 7 foot with wye and reconnect to kitchen sink drain . Not responsible for any concrete repair or replacement.

Upon arrival manifold behind heater was leaking on right side by elbow. Piping is polybutylene. Removed old manifold and replaced with copper fittings and pipe. Tested all no leaks Upon inspection heater is over 10 years old. Replaced with a Rheem 40 gal medium 4500 watt heater. Comes with a 6 year parts and labor warranty. Set temperature to 127 degrees, all fixtures have hot water.

Upon arrival I found master bathroom toilet leaking on inside , to fix the problem I will need to replace flapper, fill valve and toilet supply line

Installed new 3/4 and 1/2 Uponor lines from downstairs by washer are to vanity with 2 new emergency stops, hot and cold lines and connect to existing water lines that are currently poly butylene. New emergency stops are installed and ready for vanity to be reinstalled. Not responsible for drywall repair or any damage to vanity. Tested no leaks . Not responsible for any other areas that might be affected due to polybutylene piping that runs through rest of home. Sent estimate for 40 gal 4500 watt medium heater.

Upon inspection customer stated leak in walls noticed water damage in walls in laundry room…cut wall to look for leak…not responsible for any drywall repairs Opened drywall found 3/4 pipe and 1/2 pipe which is poly buetalene. Noticed water coming from 2nd floor, from vanity. Capped off both lines 3/4 and 1/2 in going to 2nd floor bathroom, that feed vanity. Tested no leaks, advised customer there will be no water to upstairs vanity till repaired. Will provide estimate to repair. ………Not Responsible for any drywall repairs…… Contacted Entrusted

Arrived to customer, found that main line was backed up. We presented estimates for running k 69 snake machine and To evaluate sewer with camera after, customer approved. After running about 65 feet of cable we cleared clog, we went inside and ran everything in bathroom to ensure proper drainage. We then ran camera to evaluate sewer line and found that cast iron is in good conditions with buildup, due to this, we would recommend Hydro jetting of sewer line to help prevent clogs of toilet paper and such.

On arrival Water coming out of laundry room wall Half inch CVC pipe and fittings on cold side broken in wall of laundry room/guest bath performed leak detection .opening lauder room wall exposing 1/2 CPVC pipe that was broken in three areas.shut water off at meter removed broken pipe and fittings.installed new. Turned water on tested good

Came out today to diagnose a leak coming from the main valve outside customers unit. The original gate valve was spraying from the packing when she tried to shut off her unit. We cut out old valve and replaced with a brand new ball valve and tested extensively to ensure no leaks or issues

Performed leak detection 3 1/2 hours . Customer had leak from kitchen sink on hot line had to open up concrete wall behind kitchen sink remove dishwasher witch we had to cut out to remove and remove water heater to track the leak to the manafold witch we capped off and abandoned the leaking line to stop the leak customer is responsible for all drywall and concrete repairs and customer is aware that we could not salvage the dishwasher when it was removed. Recommend a single line reroute to supply hot water to the kitchen sink.

I came out today for no hot water in the house. After looking at the water heater the ball valve was in the off position. When I turned it on the house had hot water. I went to the kitchen sink and turned the faucet on it had hot water. After turning the water heater on I could hear a hissing noise coming from underneath the kitchen sink. The homeowner also told me that the kitchen floor was getting warm underneath the tile. I provided an estimate for the leak detection for the first hour and a half which is 598.82. Anything after the hour and a half it would be an additional 388.00. Once the leak is found we will go over the options for the repair. We will be able to apply back a portion or all the leak detection price depending on the scope of the repair if the homeowner agrees to move forward with the repair.