Plumbing Repair Service In Oakland Park, FL

Upon arrival, I submitted an estimate for a whole home sanitary re-pipe and customer agreed to estimate and applied for financing. At this time, the office manager is working out the finance details in order to get this job started due to it being a business and the business is shut down due to the sanitary issues.. This is a permitted job

Upon arrival, customer had a whole house stoppage, mainly controlled to the right hand side of the property and two bathrooms. After pulling the toilet and sneaking the lines to clear the stoppage, I proceeded to camera the existing system. While camera ring the system, customer has a collapsed cast-iron pipe on the west side of the property going towards the master bathroom area, along with having a huge chunk of the broken cast-iron still wedged in the existing PVC addition that was added onto the house. At this time, customer would was advised to not use the side of the house for an extended period of time due to the stoppage will continue. Upon customer request, I replaced one emergency stop valve in the right hand side bathroom. Also, upon customer request, I provided a leak detection service due to a severe leak and the main waterline along with the house is holding pressure. The only significant drop and pressure is whenever you turn on the pump to the waterfall and there is a l

Upon today visit we are installing two 4” spread lavatory faucets with tubular p trap drain assemblies. After installing new parts and pieces we tested each sink multiple times for proper functionality. Everything is operational as it should. Thank you for calling John The Plumber -Shane

Cleared main line stoppage from the roof vent above the guest bathroom. Used five cables to fully clear the blockage. During the process, I pulled out light roots from the line, indicating root intrusion. Customer mentioned they had been flushing “flushable” wipes. I explained that no wipes are truly safe to flush—especially with cast iron piping—and advised against continuing this practice to prevent future blockages. Recommendations: Strongly recommend a camera inspection of the main line to assess the extent of root intrusion and overall condition of the pipe. Testing: Ran both showers and flushed all toilets multiple times to ensure proper flow. All fixtures are now draining correctly, and the main line is clear at this time.

Arrived to location, customer wanted tub spout replacement in master bedroom. Tub spout was already removed, customer bought delta trim kit but kit will not fit with trim installed currently. 1/2 inch copper piping is also damaged so we suggested replacement of shower body with moen valve and repair kit and also replacement of tankless water heater. Job details Moen Tub and Shower valve with repair plate (Chrome) REPLACING YOUR OLD 2 or 3 HANDLE T&S VALVE WITH A SINGLE HANDLE MOEN IS A GREAT WAY TO FIX YOUR PROBLEM AND UPDATE YOUR BATHROOM AT THE SAME TIME. MOEN PROVIDES A LIFETIME WARRANTY ON ALL OF THEIR PRODUCTS. After installing the shower valve, water was turned on and tested. Shower valve is operational.

Received a call from the property manager regarding an active water leak at the property. Upon arrival, I met with the property manager on site, who directed me to the main emergency water shut-off valve. The leak was identified at the transition adapter connected to the valve. I assessed the issue and provided an estimate to replace the faulty adapter and install a new ball valve. The estimate was approved on site. The repair was completed as outlined. A new ball valve was installed, and the system was tested thoroughly. No leaks or issues were found following the repair, and the system is now functioning properly.

Client called John the Plumber out for an object stuck inside the toilet of the kids bathroom. To fix this issue I told the client that we would have to remove the toilet and remove the object from the bottom of the toilet with a toilet auger. After removing the toilet, we found a toy wrapped in cloth at the bottom of the toilet. Removed the object and reset the toilet. After resetting the toilet tested the toilet by flushing toilet paper. Toilet is working properly. Client had a toilet in the master bathroom that they wanted to be reset to clean stains in the caulking. Removed the toilet and cleaned the old caulking and reset the toilet with new caulking.

Upon arrival the homeowner showed me to the secondary bathroom that was backed up I ran the tub and it started to fill up after a couple of minutes. I then went on the roof and ran 60 feet of cable with the sewer machine to clear the stoppage. I didn’t pull anything out on the cable. After running the sewer machine the tub cleared. I ran all of the fixtures in the bathroom, and flushed the toilet several times. I even had the homeowner flush the toilet to make sure that she was getting the same flush that she had before the stoppage. Everything is flushing and draining good now.

Customer called John the plumber out today because his kitchen faucet is not producing any water out of both hot and cold sides. After doing a brief inspection, technician came to the conclusion that the issue with the faucet was the head. Technician gave customer a few options. Customer decided to go to Home Depot and attempt to get a new faucet head. Customer will contact us back if there’s any issues.

Work Performed: *Removed and disposed of old, broken cleanout. *Installed new 4-inch cleanout in its place. Status: ✅ New cleanout installed properly ✅ System is functioning as expected ✅ Work area cleaned up after completion

*1 year JTP MEMBERSHIP *Remove and reset toilet to fix a leak at the base and the stop the toilet from rocking.(further estimate for any other repairs may be given if there is any issues with the toilet flange) *Clients toilet flange is sitting below the floor and needs a flange spacer to raise the flange to the correct level. After installing the spacer will reset the toilet and seal the base of the toilet.

Upon arrival customer wanted to update 2 lavatory sinks as well as kitchen sink. Further inspection both toilets needed a minor rebuild and since we are doing quite a bit of work we were able to do two minor rebuilds as a courtesy for customer. Customer signed estimate for us, we however just installed kitchen faucet to old valves and diagnosed shower valve. We will return to perform two minor rebuilds, install two lavatory faucets with tubular drain assemblies and emergency stops, install two duel emergency shut offs under kitchen sink. We will potentially install a shower cartridge when we return depending on further discussion with office due to left side of supply to valve being in poor condition. Customer paid deposit of 1500 towards work performed and future work to be scheduled. Thank you for choosing John The Plumber -Shane

Upon arrival Will showed me the old water heater and wanted an estimate to replace it. I went over options with him for replacing the water heater and bring it up to code. He agreed with the estimate for replacing the water heater. After the estimate was signed I proceeded to check the power, and found that there was no power to the heater. We replaced the breaker, and that didn’t resolve the issue. I then installed the new water heater along with a booster pump. After the installation I turned the water back on to test for leaks. There are no present leaks. I also raised the temperature to 125 degrees. The electrician came out to troubleshoot the line. I showed them a switch that was hidden on the wall underneath the shelving which I turned on. I then retested the power going to the junction box where I installed a new switch. It was still not reading the right voltage. After the electrician did his diagnosis he found that there was the right voltage going to the old switch. They are

We met with the owner of the business, who explained that the hair trap is currently locked tight and will not come loose. We confirmed that we can remove it, but explained that unscrewing the trap carries the risk of the hair trap breaking. The trap is a Zern model, which typically costs between $500–$600 to replace. During our inspection, we also noted that the PVC piping on both sides of the trap appears corroded and shows signs of leakage. The owner stated she will order a new basket strainer. Once the replacement basket strainer arrives, we will return to perform the following work: • Install the new basket strainer. • Remove the cover, spray-paint it, and reinstall. • Reconnect all drainage. • Loosen and lubricate the nut on the Zern trap so that it can be serviced in the future. We also provided the owner with a small amount of Clobber drain cleaner and explained that it is extremely dangerous. We advised her that we are not liable for any injury or damage that may resul

CCN: 2T25-Z5RB SERIAL # 60026 DUE IN BSI 09/09 YEARLY

John the plumber arrived to the customers home today to do a maintenance call. When customer greeted technician at the door, she informed the technician at the water heater is working perfectly fine with no issues. Customer had a few questions for the technician regarding a bathroom and kitchen faucet. Based on the degree of stiffness in the faucet handles, technician recommends that customer gets the faucets replaced. Customer is going to be remodeling the apartment shortly, so the faucets will be changed out at that time. Technician will still give customer a few estimates on getting the faucets replaced.

Customer called John the Plumber out today because his water heater is giving him some issues where the burner is not staying lit. Because customer has a warranty with us. The only thing the warranty covers is the thermal couple. Customer will have to pay for a new burner assembly. Technician gave the customer a few options and they’re leaning towards purchasing a new tankless water heater and having us come out to install it.

On arrival found master bathroom tub backing up. Used drill snake through over flow 12’ to remove hair. Filled tub and drained, tested good. Rinnai tankless water heater on right side of home. Customer just moved in suggested to descale tankless. Ran vinegar through system for half a hour. Tested work good.

Upon arrival customer had an individual flush a toy down toilet. We used toilet Uber to relieve blockage and got toilet to flush, still weak. In order to fix this problem we presented options to either remove toilet from floor to remove object from toilet, or replace toilet. Customer chose to replace toilet. After installing new toilet, tested for proper functionality. Working as it should. Thank you for calling John The Plumber -Shane

Upon arrival the homeowner had multiple items that she wanted addressed. They were connecting the ice maker line to the new refrigerator, installing a customer supplied garbage disposal, a new customer supplied pop-up in the hallway bathroom lavatory sink, and installing a new customer supplied pop-tub drain in the master bathroom. I also tightened the handle in the shower in the hallway bathroom. After installation of everything we ran the water to make sure that everything was working properly. Everything is working properly with no leaks.

This invoice is not for a service call. Plumber to write up 2 estimates for bathroom remodels (master and hallway bathrooms).

Investigated slow drainage issue in hall bathroom sink. Removed and inspected the P-trap, found and cleared debris obstructing flow. Cleaned and reassembled the pop-up drain assembly. Conducted functional test by filling and draining sink; system is now operating properly.

Upon arrival, I proceeded to remove the existing tub in the hall bath due to mold issues And trusted is on site now to mitigate the area and Joel from interested will get back with me with a sketch of installation of new fixtures during remodel so I can properly submit my estimate

Upon arrival customer was having an issue with toilet when it flushes. We determined issue was due to a fill valve not operating properly. Further inspection shut off valve to toilet was an old style multi turn valve and it will need to be updated. We went ahead and removed and replaced both fill valve as well as flush valve seal. Toilet is now flushing and refilling. Estimate provided for updating emergency shut off. Thank you for calling John The Plumber -Shane

We arrived today to provide estimate for tanked to tankless water heater conversion. The tankless natural gas water heater must be installed a minimum of 4 feet away from any operable window, door, or any source of ignition, in compliance with local code and manufacturer specifications. Proper exterior wall space must be confirmed to accommodate unit clearances, venting, and mounting hardware. Gas Line Installation: A new natural gas line will be routed from the existing gas meter to the tankless water heater's location. Gas sizing calculations will be performed to ensure adequate supply based on the unit's BTU rating and other gas appliances in the home. Electrical Requirements: The tankless water heater will require a dedicated 120V GFCI-protected electrical outlet at the unit’s location for operation. Electrical work will be coordinated to ensure code compliance and proper grounding. Water Line Modifications: Existing hot and cold water lines from the current electric tank system